Halmatic (GB) 30 used
Visible in Shotley, UNITED KINGDOMCharacteristics
- Type
- Category
- Year1990
- Length9.14m
- Width2.74m
- ConditionUsed
- Hull Material
- Keel Type
- Draft1.22m
- Water Tank140l.
- ReferenceESP45_8087_9336499
Localization
- Visible inShotley
- CountryUnited Kingdom
Engine Informations
- Nb. Engine1
- Engine BrandVolvo Penta
- Power18hp
- FuelDiesel
- PropellerInboard
- Engine Infos.2002
- Year1990
Description
ACCOMMODATION
The accommodation offers up to five berths and there is full standing headroom and excellent stowage throughout. In the forecabin there are two singles with stowage under. Opening hatch to foredeck. Good sized heads compartment to starboard with a Lavac marine toilet, washbasin & shower. Good sized hanging locker opposite.
Moving aft in to the saloon, there is a single settee berth to port with a trotter box. Fixed table with drop leaves to centre and a L shaped settee berth to starboard that converts into a double. The chart table in the starboard aft quarter instruments and control panel. The galley is opposite to port with a Taylors 043 two burner gimballed gas cooker with grill and oven. Coolbox. Stainless steel sink. Pressurised hot and cold water system throughout. Eberspacher diesel fired hot air central heating. New headlinings in 2014. Curtains.
MECHANICAL SYSTEMS
Located behind the companionway is the Volvo Penta 2002, three cylinder diesel engine, 18hp. Electric start. Freshwater cooled via heat exchanger. Shaft drive to Feathering Bruntons three bladed propeller. Single lever control. 58 litre fuel capacity. The engine has been serviced each year by its owner who is an Engineer.
ELECTRICAL SYSTEMS
Two 12 volt Rolls AGM domestic batteries - 2021
12 volt engine start battery - 2021
Alternator charging
Battery state indicator
240 volt shore power with outlets
Cetek M200 battery charger
Immersion heater
USB outlets
SPARS & SAILS
Masthead rigged Bermudan sloop. Deck stepped anodised Selden mast and boom (2012). Stainless steel standing rigging (2012). Terylene running rigging (2012). Two Anderson two speed sheet winches. Two Antal two speed halyard winches. One Antal reefing winch. Fully battened slab reefing mainsail. Headsail furling system. Spinnaker pole. Whisker pole. Harken mainsail cars.
Mainsail - Dacron - Dart Sails - 2012
Genoa - Dacron - Dart Sails - 2012
Spinnaker - 1990
Cruising chute - Westaways - 1990
Storm jib - Westaways - 1990
DECK EQUIPMENT
CQR anchor with approximately 30m of chain
Manual anchor windlass
Sprayhood - new windows 2023
Beaching legs
Cockpit shower
Mainsail cover
Various fenders & warps
Boarding ladder
NAVIGATION EQUIPMENT
Incastec speed & log instrument
Incastec depth instrument
ICOM VHF
AIS receiver
Furuno MFD8 chartplotter & radar
Plastimo steering compass
Phillips GPS
Raymarine 2000 autohelm
Clock and barometer
SAFETY EQUIPMENT
Manual bilge pump
Electric bilge pump
Fire extinguishers
Fire blanket
Gas alarm
Do detector
Jackstays
Danbuoy
Deck light
Horseshoe lifebuoy
Radar reflector
4 person life raft
CONSTRUCTION
Moulded by Halmatic in 1998 and first launched in 1990 after being fitted out by her first owner to a very high standard. White GRP hull with style stripes. Teak toe rail. White GRP superstructure with moulded non-slip to deck. Long keel with cast iron ballast. Keel hung rudder. Tiller steering. Aft self draining cockpit. Afrormosia laid cockpit seating. The hull was coppercoated in 2015. Custom Gebo windows. Lewmar portlights with new acrylics.
Two owners from new.
OWNERS COMMENTS
This is not your stock Halmatic 30 and it’s not just the quality of the fittings or the many hours spent considering and sourcing the best options during her build. She’s had two owners, both Engineers (the latter a Naval Architect) and has been Part 1 registered from new. What makes her unique is that in spite of being built to original plans (supplied) her fit out required that all panels be removable to provide 100% access to all systems and areas. As someone who has inspected over 400 boats for CE compliance I can tell you the difference between a quality build and a fly by night is attention to detail in making all systems easily accessible, a concept which many supposed high end builders have still to fully implement. But I digress…
Moulded as one of the last H30 in 1988, the superior fit out was by the first owner and his cousin, a master shop fitter. Other than the main bulkheads, supplied as standard, the rest of the interior wood came from stock held back from 1955 when an early 20C bank building was stripped. Due to the care taken, though appearing as a standard H30 layout the quality of materials and workmanship is without doubt superior to factory.
Unique to this boat are the custom made Gebo (NL) fixed windows which have modern radius, rather than old fashioned mitre corners and are of superior quality too. The portlights are Lewmar (old standard) with new acrylics and the main hatch is a Canpa Lowline composite model with new acrylic and seal (the owner is also part owner of Eagle Boat Windows). The smaller saloon hatch is another Gebo unit.
The entire rig (mast, boom, vang, pole, standing/running rigging, fully battened main, genoa and furlex) was replaced in 2012 with Atlantic/Selden spars and sails from Dart Sails of Dartmouth. At the same time a new Furuno commercial grade plotter, radar and AIS receiver was installed to complement the existing older (but fully functioning) GPS, speed/depth instruments and Raymarine auto/tiller pilot. The Furuno systems can also be connected to a laptop or similar. The cost of these updates in 2012 exceeded £19,000.
In 2015 her bottom was coppercoated (£3,500) and this has received a number of updates since. Also, at this time a Bruntons 3 blade folding prop was fitted (£1,500).
She has two spinnakers, original, but in excellent condition. One is a symmetrical kite, the other a cruising shute, both of which can be used with the sock which has a moulded GRP mouth to ensure easy and reliable use. There is also a storm jib (unused) which sets on a removable inner forestay.
The battened main utilises harken rollers to ensure easy hoisting and control and the sail has three slab reefing lines led to the mast winch.
The engine is the original Volvo Penta 2002 which has been serviced by the Engineer owners annually from new. This has indirect (FW) cooling which has recently been removed, cleaned/checked and refitted with all new seals.
Fitted from new with pressurised hot water, the original calorifier had rotted by the last change of ownership and been removed. This has been replaced with a stainless steel unit (AC and engine heating) along with a new FW pump (Jabsco). Additionally a cockpit shower is fitted which is particularly useful for a post-swim washdown. The heads features a deep basin (to aid hair washing) and shower attachment (there is a separate shower drain pump). The galley also has pumped hot/cold water as well as a hand FW pump. The galley sink drains via a foot pump (to avoid downflooding risk when heeled – the heads sink drain has an easily accessible valve to be closed when heeled).
The current owner has also installed AC systems using BlueSea (US) panels and Cobra tinned cables (the best) with breakers for shore power, the calorifier, a new Cetek M200 charger and numerous 240v AC plug sockets c/w USB ports.
Main house batteries (2) were replaced with superior Rolls S12-128 AGM units a couple of years ago. The engine battery is now five years old but holds good charge and can be linked in parallel with the house units if necessary.
There is a standard (H30) insulated cold box, but also a small 12v fridge unit. AC wiring has also been fitted should a new owner wish to install a 240v refrigeration unit within the cold box.
The cooker is a Taylor 043 gas unit with twin rings and an oven, plus a toasting grill. There is also a US made gas BBQ which is cockpit mounted in a rod holder and connects directly to the locker gas supply.
There are five berths (standard). To starboard in the saloon the table drops to form a double. In the bow there are two single berths, but an infill structure (removeable) would allow this to be used as a double (only the infill cushion is required to complete). There is dry storage under all berths.
The electric bilge pump (under engine) is supplemented by a large capacity manual gusher pump mounted in the aft cockpit locker.
Washboards (GREY tinted Acrylic with SS vent) are new for 2024.
She also has beaching legs (which I have fitted on hard standing but never used in earnest, they seem very sturdy.
In my capacity at Eagle Boat Windows I often get contacted by people looking to buy a yacht and my advice is always the same – ‘buy the best you can’. Buy a sorted yacht, rather than a project that you will spend much time and money on and still not be happy with. You may think this yacht expensive for a H30 and she is, but £15k will disappear in a flash on a project…. When I first saw LB (as we call her) I knew she was a peach, the best she could be, built with love, care and incredible attention to detail. The surveyor agreed and struggled to find fault, eventually settling on needing an updated gas regulator. That’s how good she was.
Are there things to do. Some I guess, more wants than needs. The Afromosia cockpit locker lids would look better with teak and I would be minded to have a cockpit grating under foot. The air heater (Eberspacher) hasn’t been used for a while and probably needs recommissioning. Otherwise I’m seriously finding it difficult to suggest work for a prospect buyer. I just hope they actually use her more than I have found time to….
Show More
Price
This ad was viewed 45 times and last modified 20/04/24
Learn more about CLARKE & CARTER SUFFOLK
General Informations
Suffolk Yacht Harbour
IP10 0LN Ipswich, United Kingdom
www.clarkeandcarter.co.uk/
Steve
Contact Seller
Activities
Used or new nautical ads from same seller
- 2024
- Lg. 19.81m.
- 2024
- Lg. 13.41m.
More offers for sale to see ?
Useful Links
Complementary products that may be useful
Boats for sale similar as this Halmatic (GB) 30
Harbour berths for sale or rent which could be suitable for this ad of Halmatic (GB) 30 with 9.14m of length and 2.74m of width
You want to send this ad to a friend electronically:
Halmatic (GB) 30 - 29.950 £
You want to report an error on this announcement of:
Halmatic (GB) 30 - 29.950 £
Create an alert to get the latests ads matching this search emailed to you
Halmatic (GB) 30 - United Kingdom
Sign up to receive email price drop notifications when prices change on specific :
Halmatic (GB) 30 29.950 £ - United Kingdom