Corby 36 Sıfır

Oui is a fantastic allrounder and a ‘rating weapon’, especially fast in lighter airs. She is also a great short-handed boat, with the option of a long prod (included) for asymmetric set up. She has a full H5000 Electronics setup, with AIS and autopilot equipped for longer distance racing.  Corby 36’s are competitive and winning around the world. Fully ‘re-Corbied’ under the guidance of John Corby in 2017 with a new keel, stern and bow profiles, fresh Awlgrip topsides and fully faired with new antifoul.

A spectacular ‘no expense spared build’, with a full inventory and a recent refit gives superb value for money. Oui (Originally Inga from Sweden) was built in 2010 by Richard Goransson to race IRC in Sweden. She is stored out of the water in Cowes. 


Summary

Name: Oui (originally Inga fro Sweden) Make: Corby Model: 36 Year: 2010 LOA: 36ft/11m Beam 3.15 m Displacement: 4956 kg Draft: 2.29 Hull: Glass Reinforced Plastic Keel: Fin Keel with bulb Drive: Sail Drive Berths: 8 Engine: Lombardini Location: Cowes, UK


Build

A spectacular ‘no expense spared build’, with a full inventory and a very recent refit gives superb value for money.

Oui (Originally Inga from Sweden) was built in 2010 by Richard Goransson to race IRC in Sweden.

Hull Material/Construction: Composite hull, Cedar strips planks scarfed together, then faired, sheathed in carbon fibre,

Finish: Hull fully faired and painted with Awlgrip paint.

Hull bottom antifouled and polished.

The superstructure is a carbon fibre/foam sandwich composite.

Carbon used in reinforcement areas internally.


Spars & Rigging

Marstrom Carbon Mast with Nitronic Rod Rigging,

Carbon Boom

Harken Carbo head foil

Hydraulic mast jacks and pump in box with large selection of shims

Short Carbon bowsprit

Long Carbon bowsprit with mid and end tack points

Carbon Spinnaker pole

Carbon tiller arm

Aluminium tiller arm

2 Masthead Spinnaker halyards
2 jib halyards
2:1 main halyard
Staysail halyard
2 x tack lines
2 x Spinnaker sheets
1 x peel spinnaker sheet
2 x Spinnaker guys
5 x Jib sheets
Continuous mainsheet
Spinnaker staysail sheets


Sail Inventory

North Sails (2015)

Mainsail (2reefs 3DL 50/50 aramid carbon 16800 DPI) A4 Gennaker (SK150) 2014

Mainsail (1reef 3DL 50/50 aramid carbon 16800 DPI) J1.5 Jib (3DL 50/50 aramid carbon 14700 DPI) J2 Jib (3DL 50/50 aramid carbon 16800 DPI) J3 Jib (3DL 50/50 aramid carbon 22400 DPI) A0-3 Code Zero (CZ30) A1 Gennaker (SL50) S2+ Spinnaker (SK90) S2 Spinnaker (SL60) Storm Jib Trysail Jib Top Spin Staysail Jib Top staysail
Deck Hardware

6 x Spinlock XX power clutches for spinnaker, genoa, main halyard and tack lines 2 x Spinlock 0814 jammers with ceramic Jaws 2 x Harken primary 3-speed racing winch B50.3STR-FD 2 x Harken 46, 2-speed cabin top winches with cross-sheeting base 2 x Harken 40, 2-speed mainsheet winches 4 harken long winch handles 2 short winch handles Harken main track and harken turning blocks below deck traveller purchase Genoa tracks with adjustable 12:1 up/down and 8:1 side to side internal purchase Hydraulic Backstay control with main trimmer up and down lines Karver spinnaker staysail furler Harken reflex unit 1 code zero furler Equiplite mast base blocks Harken spinnaker blocks Deck rope bags at mainsheet and primary’s Under deck halyard bags @ hatch


Electronics

B&G H5000 Hercules CPU with Performance software upgrade from Hydra software B&G H5000 Autopilot with 2 x WR 10 pilot remotes Mast 3 X Garmin GNX 120 7inch multi displays on H5000 2 x B&G Graphic display units in cockpit B&G Zeus2 12inch Plotter at chart table with charts B&G ZG100 GPS antenna compass Carbon VM HUB&G Precision compass B&G DD-15 rudder feedback B&G Autopilot pilot ram B&G V50 VHF B&G ais-400 - AIS in and outMoax network hub & Wi-Fi B&G access point displaying on tablet or phone B & G VHF antenna B & G Wind wand  

Fusion MS-RA50 Radio with 2 cockpit Loudspeakers 1 X 110AH service battery 1 x 75AH engine battery
Inventory

Safety:

Fortress aluminium folding anchor Chain and anchor warp Radar reflector Jack lines 3 double tethers with overload indicator 5 single tethers Horseshoe float with boat name Johnbouy – danbuoy Engine:

Model Lombardini LDW1404M Sail drive with 2 bladed folding propellor Below Deck:

4 x Flush closing through hulls Jabsco Manual toilet Duel burner gas hob 55L flexible freshwater tank Fresh and saltwater pump taps in carbon sink 3 x powder fire extinguishers & Fire blanket Bunk Cushions mid and aft 2 pipe cots
Features

CompassAsymmetric spinnakerDepthsounderWind speed and directionTillerBattery chargerMarine headVhfShore power inletCockpit speakersNavigation centerManual bilge pumpSea water pumpPlotterGenoaOvenSpinnaker poleGpsBattened mainsailSpinnakerAutopilotLog speedometerElectric bilge pumpRepeaterMainsail coverIn this case we are acting as brokers only.  The Vendor is not selling in the course of a business.  Whilst every care has been taken in their preparation, the correctness of these particulars is not guaranteed.  The particulars are intended only as a guide and they do not constitute a term of any contract.  A prospective buyer is strongly advised to check the particulars and where appropriate at his own expense to employ a qualified Marine Surveyor to carry out a survey and / or to have an engine trial conducted, which if carried out by us shall not imply any liability for such engine on our part.

 

Note to seller and purchaser:  If the boat you are selling or purchasing is registered, please ensure that the registration is completed after the sale of the boat.  If the purchaser wishes to cancel the registration is the duty of the seller to contact the Registry and inform them that the registration is to be cancelled.  If the purchaser wishes to continue with the registration, it is the duty of the purchaser to complete the relevant forms and post off the bill of sale to the Registrar.

Daha fazla göster